Cnb IGP1030 Manuel d'utilisateur télécharger pdf (Page 32)

XNET User Manual

32 / 53

ITEM DESCRIPTION

IPv4 Address

Configuration

Enable DHCP

Turns DHCP on or off.

Check DHCP checkbox to get an IP address automatically from the

network using DHCP protocol. Obtained IP address can be viewed by

IP Installer.

(Note) If the network does not use DHCP server, the product will wait

for server’s response for two minutes and restart with its previous IP

address.

IP address

Enter an IP address.

Configure IP address after checking IP address range configuration of

the router where the XNET product is connected.

Subnet mask

Enter Subnet mask.

Use this when you want to access only from the same subnet by

masking out upper portion of the IP address.

Use 255.255.255.255 when you want to connect from one PC only.

Default router Enter the address of Default router.

DNS

Configuration

Domain name Enter Domain name.

Primary

DNS Server

Enter primary DNS address.

Secondary DNS

Server

Enter secondary DNS address.

NTP

Configuration

Network

address

Enter address of NTP (Network Time Protocol Server.)

NTP server is used when “Synchronize to NTP Server” is selected in

Date&Time page.

Host name

Configuration

User

the host name

Enter Host name

Ethernet

Address

Ethernet

address

Enter Ethernet Address.

Save - Applies and saves changes.

Reset - Recalls previously saved configurations.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 52 53

Commentaires sur ces manuels

Pas de commentaire

Cnb IGP1030 Manuel d'utilisateur Page 32

Commentaires sur ces manuels

Produits connexes et manuels pour Caméscopes Cnb IGP1030